A Nexus among Reliability Improvement of Distribution System with Optimal Placement and Capacity of Wind-Based Distributed Generation Management

Syahrial Shaddiq

Abstract


Along with the world population growth, the need for a source of electrical energy is higher, so a reliable system with higher capacities is expected. Renewable energy becomes an alternative that supports the goal of reducing the risk of disruption, thus increasing the distribution system’s reliability. A lot of industries and public settlement uses renewable sources of energy as an alternative power supply to comply their energy needs. This research uses wind turbine as a source of renewable energy in the distributed generation (DG). However, the required investment in wind-based DG is commonly considered too costly to deploy and require a proper planning on its placement method. The flower pollination algorithm (FPA) method could be a solution to achieve optimal placement of wind-based DG, thus increase the distribution system’s reliability, which is indicated by minimum energy not supplied (ENS) index.

Full Text:

PDF

References


T. Power and S. Reliability, “RTD2004-66012,” 2004.

Y. M. Atwa, S. Member, S. Member, M. M. A. Salama, and R. Seethapathy, “Optimal Renewable Resources Mix for Distribution System Energy Loss Minimisation,” vol. 25, no. 1, pp. 360–370, 2010.

Y. M. Atwa, S. Member, and S. Member, “Supply Adequacy Assessment of Distribution System Including Wind-based DG During Different Modes of Operation,” vol. 25, no. 1, pp. 78–86, 2010.

G. Desrochers, M. Blanchard, and S. Sud, “A Monte-Carlo Simulation Method for the Economic Assessment of the Contribution of Wind Energy to Power Systems,” IEEE Trans. Energy Convers., vol. EC-1, no. 4, pp. 50–56, 1986.

M. C. Bozchalui, M. IEEE, R. Sharma, and M. IEEE, “Optimal Operation of Energy Storage in Distribution Systems with Renewable Energy Resources,” no. 2.

H. Chen and R. Billinton, “Generating Systems using Wind Energy,” no. 97, pp. 47–52, 1997.

A. B. Culaba, L. A. G. Lim, and A. H. P. Unit, “Design of Yaw B Brake System for Horizontal Axis Wind Turbine Generator,” 2015.

S. H. Jangamshetti, S. Member, V. G. Rau, and S. Member, “Normalised Power Curves as a Tool for Identification of Optimum Wind Turbine Generator Parameters,” vol. 16, no. 3, pp. 283–288, 2001.

G. Allan, I. Eromenko, M. Gilmartin, I. Kockar, and P. McGregor, “The Economics of Distributed Energy Generation: A Literature Review,” Renew. Sustain. Energy Rev., vol. 42, pp. 543–556, 2015.

B. Sultana, M. W. Mustafa, U. Sultana, and A. Rauf, “Review on Reliability Improvement and Power Loss Reduction in Distribution System via Network Reconfiguration,” vol. 66, pp. 297–310, 2016.

M. Stojkov and S. Nikoiovski, “Estimation of Electrical Energy Not Supplied in Reliability Analysis of Distribution Networks,” no. 1, pp. 967–970, 2004.

S. Hakimi, H. Afrakhte, and M. Jabbari, “Probabilistic Method for Optimal Placement of Wind-based Distributed Generation with Considering Reliability Improvement and Power Loss Reduction.”

X. S. Yang, “Flower Pollination Algorithm for Global Optimisation,” 2013.

X. S. Yang, M. Karamanoglu, and X. He, “Multi-objective Flower Algorithm for Optimisation,” Procedia Comput. Sci., vol. 18, pp. 861–868, 2013.

T. Ackermann, G. Andersson, and L. Söder, “Distributed Generation: A Definition,” Electr. Power Syst. Res., vol. 57, no. 3, pp. 195–204, 2001.

S. M. Shahidehpour, “Reliability Evaluation of a Three-area Power System,” Electr. Power Syst. Res., vol. 10, no. 3, pp. 227–233, 1986.

A. Koshti, “Reliability Evaluation of Distribution System Accounting Distributed Generation Using Functional Link Network,” pp. 25–30, 2009.

D. R. Joshi, S. Member, S. H. Jangamshetti, and S. Member, “A Novel Method to Estimate the O & M Costs for the Financial Planning of the Wind Power Projects based on Wind Speed — A Case Study,” vol. 25, no. 1, pp. 161–167, 2010.

K. S. Rao and M. N. Rao, “Multiple Distributed Generator Allocation by Harmony Search Algorithm for Loss Reduction,” Proc. - ICETEEEM 2012, Int. Conf. Emerg. Trends Electr. Eng. Energy Manag., pp. 59–64, 2012.

M. H. Sulaiman, M. W. Mustafa, A. Azmi, O. Aliman, and S. R. A. Rahim, “Optimal Allocation and Sizing of Distributed Generation in Distribution System via Firefly Algorithm,” no. June, pp. 6–7, 2012.

K. Nadhir, D. Chabane, and B. Tarek, “Firefly Algorithm for Optimal Allocation and Sizing of Distributed Generation in Radial Distribution System for Loss Minimisation,” 2013 Int. Conf. Control. Decis. Inf. Technol. CoDIT 2013, pp. 231–235, 2013.

D. C. Vega, J. A. Marin, and R. T. Sanchez, “Pitch Angle Controllers Design for a Horizontal Axis Wind Turbine,” 2015.

L. Zhang, L. Ma, K. Li, S. Gan, J. Yan, and X. Xu, “NARX Models for Predicting Power Consumption of a Horizontal Axis Wind Turbine,” pp. 2–6, 2016.

A. Yadav, “Design, Development, and Fabrication of Horizontal Axis Wind Turbine,” pp. 0–3, 2016.

M. T. Do, J. Sprooten, S. Clenet, and B. Robyns, “Influence of Wind Turbines on Power System Reliability through Probabilistic Studies,” Innov. Smart Grid Technol. Conf. Eur. (ISGT Eur. 2010 IEEE PES, pp. 2–7, 2010.

K. Rohrig and B. Lange, “Improvement of the Power System Reliability by Prediction of Wind Power Generation,” 2007.

R. Karki, S. Member, P. Hu, S. Member, R. Billinton, and L. Fellow, “A Simplified Wind Power Generation Model for Reliability Evaluation,” vol. 21, no. 2, pp. 533–540, 2006.

X. Han, M. Mu, W. Qin, and A. W. S. Model, “Reliability Assessment of Power System Containing Wind Farm based on Steady-state Power Flow,” no. 3, pp. 756–760, 2010.

G. Chen, J. Zhang, M. Zhu, N. Dai, and X. Cai, “Optimised Design for Multi-MW Wind Power Converter based on Efficiency and Reliability,” 2014.

S. L. Tokyo Institute of Technology, “Wind Power and Wind Turbines,” Engineering. pp. 1–35, 2009.

C. Ordoudis, P. Pinson, J. M. Morales González, and M. Zugno, “An Updated Version of the IEEE RTS 24-bus System for Electricity Market and Power System Operation Studies,” Tech. Univ. Denmark, 2016.

C. Darwin, “The Abominable Mystery: How Flowers Conquered the World,” pp. 1–8, 2017.

M. Ingrouille, “Understanding Flowers and Flowering: An Integrated Approach,” Ann. Bot., vol. 103, no. 1, pp. vi–vii, 2009.

N. M. Waser, T. A. Naturalist, and N. May, “Flower Constancy: Definition, Cause, and Measurement,” vol. 127, no. 5, pp. 593–603, 2007.

I. Pavlyukevich, “Levy Flights, Non-local Search and Simulated Annealing,” J. Comput. Phys., vol. 226, no. 2, pp. 1830–1844, 2007.

A. K. Rajeevan, “Identification of Reliability of Wind Power Generation and its Mathematical Modeling,” 2013.

B. K. Subramanian, A. B. Attya, and T. Hartkopf, “Novel Wind Turbine Reliability Model-implementation to Estimate Wind Farms Capacity Credit,” Proc. Int. Conf. Harmon. Qual. Power, ICHQP, pp. 97–101, 2014.

R. W. Mosobi, “Modeling and Power Quality Analysis of Integrated Renewable Energy System,” pp. 0–5, 2014.

W. G. Morsi, C. P. Diduch, and L. Chang, “A New Islanding Detection Approach Using Wavelet Packet Transform for Wind-based Distributed Generation,” pp. 495–500, 2010.

Y. M. Atwa, S. Member, S. Member, R. Seethapathy, and M. A. Salama, “Effect of Wind-based DG Seasonality and Uncertainty on Distribution System Losses,” pp. 1–6, 2008.

Maiti, A. “Load Flow Analysis of Radial Distribution Network Using Linear Data Structure. Master of Technology in Department of Computer Science & Engineering (with specialisation in Computer Science), 2013.

A. Skoonpong and S. Sirisumrannukul, “Network Reconfiguration for Reliability Worth Enhancement in Distribution Systems by Simulated Annealing,” 5th Int. Conf. Electr. Eng. Comput. Telecommun. Inf. Technol. ECTI-CON 2008, vol. 2, pp. 937–940, 2008.

S. Naik, G. Naik, D. K. Khatod, and M. P. Sharma, “Analytical Approach for Optimal Siting and Sizing of Distributed Generation in Radial Distribution Networks,” no. July 2014, pp. 209–220, 2015.

M. R. Ali, “Optimasi Penempatan dan Kapasitas Distributed Generation dengan Metode Flower Pollination Algorithm,” Skripsi, UGM, 2015.

D. B. Santoso, “Optimisasi Penempatan dan Kapasitas Wind-based Distributed Generation untuk Minimisasi Losses Menggunakan Flower Pollination Algorithm,” Tesis, UGM, 2017.

S. Shaddiq, D. B. Santoso, F. F. Alfarobi, Sarjiya & S.P. Hadi, “Optimal Capacity and Placement of Distributed Generation using Metaheuristic Optimisation Algorithm to Reduce Power Losses in Bantul Distribution System, Yogyakarta”. In 2016 8th International Conference on Information Technology and Electrical Engineering (ICITEE) (pp. 1-5). IEEE, 2016.

Z. A. A. Alyasseri, A. T. Khader, M. A. Al-Betar, Awadallah, M. A., & Yang, X. S. “Variants of the Flower Pollination Algorithm: A Review”. Nature-Inspired Algorithms and Applied Optimisation, 91- 118, 2018.

M. Abdel-Basset, & L. A. Shawky, “Flower Pollination Algorithm: A Comprehensive Review”. Artificial Intelligence Review, 52(4), 2533-2557, 2019.

T. Adithiyaa, D. Chandramohan, & T. Sathis, “Flower Pollination Algorithm for the Optimisation of Stair Casting Parameter for the Preparation of AMC”. Materials Today: Proceedings, 21, 882-886, 2020.

H. Mohammadzadeh, & F. S. Gharehchopogh, “A Novel Hybrid Whale Optimisation Algorithm with Flower Pollination Algorithm for Feature Selection: Case Study Email Spam Detection”. Computational Intelligence, 37(1), 176-209.




DOI: https://doi.org/10.33365/jictee.v2i2.1174

Refbacks

  • There are currently no refbacks.


JURNAL ICTEE Published by Universitas Teknokrat Indonesia

Organized by Program Studi S1 Teknik Elektro
Web: http://ejurnal.teknokrat.ac.id/index.php/ictee/index
Email : ictee@teknokrat.ac.id.
Jl. Zainal Abidin Pagaralam, No.9-11, Labuhan Ratu, Bandarlampung
Telepon : 0721 70 20 22

Creative Commons License
ICTEE is licensed under a  Creative Commons Attribution-ShareAlike 4.0 International License.

Jumlah Pengunjung : View My Stats 

Flag Counter